Flexco
Change Country & Language   |  Site Map   |  
About Us Products Technical Support Contact Us Distributor Locator News & Events Home
Installation Instructions
Technical Tips
Safety
Replacement Parts
PDF Literature Library
Literature
Technical Support: Technical Tips > Mechanical Belt Fasteners
 E-Tools   E-Tools

Technical Tips

Print Page
Alligator® Ready Set™ Fasteners Are Not Flush and Parallel With Belt Edge:

Belt was not installed flush against the Ready Set fastener belt stops.

Fasteners were installed from 'left to right' or 'right to left'.
  • First install the center two fasteners and then install fasteners on outside edges. Finish by installing the remaining fasteners.
Cam levers were not properly engaged or are worn.
  • Tighten cam lever by turning it clockwise until a snug lock is achieved.
  • Replace cam levers.
Spring-loaded belt nails located in top block of the Alligator RSC187 are stuck or are missing. Replace top block as needed.
About Us  |  Products  |  Technical Support  |  Contact Us  |  Distributor Locator  |  News & Events  |  Home
Interactive e-Catalog  |  e-Services  |  Site Map

Flexco General Office: 1-800-323-3444 Hours: 8:00am-4:30pm CST Monday-Friday
Flexco Customer Service: 1-800-541-8028 Hours: 7:00am-5:30pm CST Monday-Friday
E-Mail: info@flexco.com
© 2008 Flexible Steel Lacing Company, Downers Grove, Illinois USA. Privacy Policy | Terms & Conditions | Legal Notices

web design by starkmedia